Advertisement
1.
The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
2.
Check and clean the sprayhead. The sprayhead holes must always remain open.
3.
With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube.
When inserted properly, no more than two inches of spring should be visible. Saw back and forth five or
six times.
NOTE – In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer
and takes less than a minute.
FIG. 2 SPRAYHEAD
CLEANING
FIG. 3 DELIMING SPRING
Page 5
10053.1 101508
Advertisement
