GE JCKS10 Owner's Manual page 12

Special features of your oven control.
+
+
+
or
12
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds until
the Reset/Off pad is pressed. This continuous 6
second beep may be canceled.
To cancel the 6 second beep:
Press the Bake and Broil Hi/Low
pads at the same time for 3 seconds
until the display shows SF.
12 Hour, 24 Hour or Clock Black-Out
Your control is set to use a 12 hour clock.
If you would prefer to have a 24 hour
military time clock or black-out the clock
display, follow the steps below.
Press the Bake and Broil Hi/Low
pads at the same time for 3 seconds
until the display shows SF.
Press the Clock pad once. The
display will show 12 hr. If this is the
choice you want, press the Start pad.
Changing the Speed of the + or – Pads
As you use the + or – pads when setting a time
or temperature, you may notice the display
changes slowly. This special feature allows you to
change the speed. To set the speed you prefer,
follow the steps below.
Press the Bake and Broil Hi/Low
pads at the same time for 3 seconds
until the display shows SF.
Press any + pad. The display will
show you a set speed between 1
and 5.
Press the Timer pad. The display
shows CON BEEP (continuous beep).
Press the Timer pad again. The
display shows BEEP. (This cancels
the one beep every 6 seconds.)
Press the Start pad.
Press the Clock pad again to change
to the 24 hour military time clock. The
display will show 24 hr. If this is the choice
you want, press the Start pad.
Press the Clock pad again to black-
out the clock display. The display will
show OFF. If this is the choice you want,
press the Start pad.
NOTE: If the clock is in the black-out mode, you
will not be able to use the Delay Start function.
Press any + pad to increase the
speed up to the number 5.
Press any – pad to decrease the
speed down to the number 1.
Press Start to activate the setting and
leave the control set in this special
features mode.