Before You Call For Service - Sharp SJ-FS79V Operation Manual

Table of Contents

Advertisement

BEFORE YOU CALL FOR SERVICE

Before you call for service, check the following points.
Problem
The outside of the cabinet is hot when touched.
When there is refrigerator noise.
Frosting or dew generation occurs inside or
outside the refrigerator.
The foods in the refrigerator compartment
freeze.
It smells in the compartment.
The control panel does notwork.
ICE MAKING
Problem
Ice maker is not producing ice.
Ice cubes are made slow
Ice cubes are small, rounded or connected.
There is protrusion or holes in ice cubes.
Ice cubes have some odor.
No water or ice cubes drop even when
performing "Ice tray cleaning".
IF YOU STILL REQUIRE SERVICE
Refer to your nearest service agent approved by SHARP.
34
SJ-FS79V_TINS-B373CBRZ 12JT [EN]Sec1:34 Sec1:34
SJ-FS79V_TINS-B373CBRZ 12JT [EN]Sec1:34 Sec1:34
It is normal. The hot pipe is in the cabinet in order to prevent dew generation.
It is normal for the refrigerator to produce the following sounds.
Loud noise produced by the compressor when operation starts
--- Sound becomes quieter after a while.
Loud noise produced once a day by the compressor
--- Operating sound produced immediately after automatic defrost operation.
Sound of fl owing fl uid (gurgling sound, fi zzing sound)
--- Sound of refrigerant fl owing in pipes (sound may become louder from time to
time).
Cracking or crunching sound, squeaking sound
--- Sound produced by expansion and contraction of inner walls and internal parts
during cooling.
This may occur in one of the following cases. Use a wet cloth for wiping frost and a
dry cloth for wiping dew.
When the ambient humidity is high.
When the door is frequently opened and closed.
When foods containing plenty of moisture are stored. (Wrapping is required.)
Is the refrigerator operated for a long time with refrigerator temp. control set at
0°C?
Is the refrigerator operated for a long time with freezer temp. control set at -21°C?
Low ambient temperature may cause placed foods to freeze even if refrigerator
temp. control is set to 6°C.
Wrapping is required for the foods with strong smell.
Deodorizing unit cannot remove all of the smell.
This may occur in one of the following cases.
The panel or your fi nger is soiled with dripping, oil and etc.
When you touch the panel with gloved hand, adhesive bandage on your fi nger,
nail or objects.
Sticker or tape is affi xed on the keys.
Touch position is slightly off from the keys.
Operate time is not enough for the keys to work.
Is there water in the water tank? (If there isn't, ice making process indication will fl ash.)
Is the water tank securely set?
Have you left the shovel or other food products in the ice storage box?
Isn't all the ice making mode set at "OFF"?
Are the ice cubes piled up at the back of the ice
storage box? (Spread out the ice cubes evenly.)
Try the ice tray cleaning. If the ice tray
cleaning works properly, wait for one day.
You may get ice again.
Has the ice making operation just been restarted?
Is it just after refi lling the tank with potable water?
Ice cubes may become small or connected to each other, especially just before or
after water supply.
If you store ice cubes for a long time, they may become smaller, rounded, lumped
together.
The protrusion you may see comes from the slits in the ice tray.
The hole comes from air bubbles in ice cubes which may be lumped together and
form bigger holes.
Is the water in the water tank old or with some odor?
Is there remaining detergent or bleach in the water tank used for cleaning the
water tank?
If ice cubes has been left unused for a long time, odors may transfer to the ice
cubes.
Is the ice storage box full with ice cubes? Have you left the shovel or other food
products in the ice storage box? (Empty the ice storage box.)
Is there water in the water tank?
Solution
Solution
Detection
lever
Detection of
full volume
7/30/12 2:02:03 PM
7/30/12 2:02:03 PM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents