Seamless Loop (Md 1, Md 2) - Denon DN-M2300R Operating Instructions Manual

ENGLISH
2,7,8 3 4 5,6

(3) Seamless loop (MD 1, MD 2)

Select "A-B LOOP" for the "LOOP BUTTON FUNCTION"
presetting.
Starting seamless loop playback.
Start playback.
Press the PLAY/PAUSE button.
1
Set the seamless loop mode.
Press the LOOP button.
2
Set the starting point (A).
Press the A button.
3
Set the ending point (B).
Press the B button.
Starting
point
4
Starting
point
Seamless loop
Alternative way to set the seamless loop starting point (A)
and ending point (B).
• After setting point A, set the cue mode, press button A, then
use the scan or search function to fine-adjust point A. (The
same can be done for point B.)
NOTE: It is not possible to use the seamless loop mode at the
same time as the hot start play or programmed play
mode.
18
1 2,7,8 3 4 5,6
Lit
Flashing
Lit
Lit
Lit
Ending
point
When the ending point (B) is
set, playback starts from the
starting point (A) with no
interuption in the sound.
Ending
point
After this, the section between
the starting point (A) and the
ending point (B) is played
repeatedly with no interuption in
the sound.
1
Leaving the seamless loop mode tenporarily.
Press the EXIT/RELOOP button while playing a seamless
loop.
5
• When the ending point (B) is reached, playback
continues without returning to the starting point (A).
Replaying a seamless loop.
Press the EXIT/RELOOP button or button B during normal
playback.
(The position at whitch button B is pressed is set as the
new loop playback ending point (B).)
6
Starting
point
• Playback returns to the starting point (A) and seamless
loop playback begins.
Switching from seamless loop playback to normal disc
playback (Setting the normal playback mode without
canceling the starting and ending points).
Press the LOOP button within 1 second.
7
• The normal playback mode is set.
(Only the loop mode is canceled. Point A and B are not
cleared)
NOTE:
The starting point (A) and ending point (B) settings are
canceled when the cartridge is removed from the
recorder.
Canceling the seamless loop setting.
Press the LOOP button for over 1 second.
8
• When this done, the starting point (A) and ending point
(B) settings are automatically canceled.
NOTE:
After canceling the seamless loop during loop
playback, it may take about 5 seconds before the
seamless loop mode is set again.
Lit
Flashing
Starting point Ending point
Flashing Lit
Ending point
Press the EXIT/RELOOP
button or button B
Lit Off
Starting point Ending point
Lit Lit Lit Off Off Off