Button Behaviour; Frequently-Asked Questions - Datavideo NVS-25 Instruction Manual

H.264 Network Video Streaming Server
NVS-25

18.2 Button Behaviour

Button
Hold for 3 seconds
STM
until Stream LED
MODE
Press Once
(Stream OFF)
MODE
Press Once
(Stream ON)
RECORD Press Once
19.

Frequently-Asked Questions

This section describes problems that you may encounter while using NVS-25. If you
have questions, please refer to related sections and follow all the suggested solutions. If
problem still exists, please contact your distributor or the service center.
No. Problems
Mode buttons on the front
1.
panel is not sensitive.
Record button on the front
2.
panel is not sensitive.
3. RTMP Local / Publish do
not work in IBBP and IBP
modes.
50
Behavior
Start/Stop Stream
Change to next
(HDMI->SDI->CVBS->)
Stop Stream ->
change to next
(HDMI->SDI->CVBS->)
Start Stream
Start/Stop Recording
Description
Solutions
It takes quite a while for the system to
switch modes after the mode button is
pressed. Please wait for at least 10
seconds.
Please wait for at least 10 seconds and if
the system does not respond, press the
button again.
As IBBP and IBP are new parameter
settings, RTMP streaming and MP4
recording only work in IPPP mode.
LED
Stream LED ON/OFF for
starting or stopping
Interface LED changed
1. Streaming LED OFF
2. Interface LED changed
3. Stream LED ON
(If there is a valid source
input)
Record LED ON/OFF