Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sibir RC1200 EGP
Summary of Contents for Sibir RC1200 EGP
-
Page 1: Operating Instructions
RC1200 EGP Type: JCB - 7 0402 Operating instructions 207.5397.07... -
Page 2: Area Of Use
Dear customer, please read the instruction book and all additional information before using the appliance. It is most important that they should be retained with the appliance for future reference! 1. Warnings and directions These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance! This product is designed to be operated by adults. -
Page 3: Installation
3. Storage of gas cylinders Liquid gas cylinders should never be stored in unventilated areas or below ground (funnel-shaped holes). Avoid direct sunlight. The gas cylinder should not be exposed to temperatures in excess of 50°C. 4. Installation To be installed horizontally on a smooth, firm or any other appropriate surface. - Page 4 If the fuse cover/carrier is lost, a replacement can be obtained from the service shops. The fuse cover/carrier must be of the same colour as that of the coloured insert in the base of the plug. In no circumstances must the plug be used without a correct fuse cover/carrier fitted.
- Page 5 To turn on (Fig. 1) Turn thermostat knob (A) clockwise to position 7/MAX. Only after approximately 1 hour will the unit become noticably cool (frost on evaporator). The temperature can be regulated using the thermostat knob: '0'=off, 1- 7 increasing degrees of coolness. After sufficient cooling (approximately 5 hours), the thermostat position can be set to a lower temperature, between 2-5.
- Page 6 When knob (A) is ineffective or if the temperature is unnecessarily too low: Turn off unit Pull out plug from socket. 8. Liquid gas operation Do not use any additional form of energy (mains/battery). The unit must not be connected to town or natural gas pipelines. It is only suitable for use with propane/butane gas (e.g.
- Page 7 ensure that there are no leaks, that the gas pipe (rubber hose) is not under tension or kinked, and that it is not in contact with hot surfaces. The connection pipe and gas bottle should always be located in positions where they will not be tripped over or otherwise inadvertently disturbed.
-
Page 8: Periods Of Disuse
4. Once sufficient refrigeration has been obtained in the cooling tank at the MAX position, the control knob should be turned to the MIN position by low outside temperatures or when the refrigerator is only lightly loaded respectively the ambient temperature is below +18°C, in order to avoid overfreezing the contents. -
Page 9: Maintenance
After a few minutes return the appliance to its upright position and switch on again. Should the unit still not fuction correctly, repeat the process several times. 16. Maintenance Changing the gas filter: the cellulose gas filter is situated at the back in the gas connection piece. -
Page 10: Technical Data
are several operating methods being used simultaneously? have warm foodstuffs been stored in the cooler? was a too large a quantity of food or drink stored at any one time? Food and drink should be so stored as to allow free air circulation. Do not use paper or plastic plates. - Page 11 Appliances bearing this symbol must be deposited at the designated local reception point for the disposal of electrical and electronic equipment. It is not permitted that this product be disposed of by way of the normal household refuse collection system. Dometic refrigerators bear this symbol on the specifications plate (data plate) to be found in the interior of the unit.
- Page 12 seal Fig 2 seals Fig 3...
Need help?
Do you have a question about the RC1200 EGP and is the answer not in the manual?
Questions and answers
What is the weight of the product please