GE JKP62G Use And Care Manual page 25

Before Setting Oven
Controls, Check These
Things:
Step 1:
Remove broiler pan, broiler rack
and other cookware from the oven.
(Oven shelves may be left in oven.
Note: Shelves will discolor during
the self-clean cycle.)
Step 2:
If ~ou ~se so~p, rinse thoroughly
before self-cleaning to prevent
staining.
A.
Oven Front Frame
B. Oven Door Gasket
C. Openings in Door
D. Oven Light
Step 3:
. Clean spatters or spills on oven
front frame (A) and oven door
outside gasket (B) with a dampened
cloth. Polish with a dry cloth. Do
not clean gasket (B). Do not allow
water to run down through openings
in top of door (C). Never use a
commercial oven cleaner in or
around self-cleaning oven.
of oven door with soap and water.
Do not use abrasives or oven
cleaners.
Step
4:
Close oven door and make sure
—
oven light (D) is off.
How to Set Oven
for Cleaning
Step 1:
Turn OVEN SET and OVEN
Controls
will snap into final position when
the CLEAN location is reached.
Step 2:
Slide Latch Handle to the right as
far as it will go.
"OVEN DOOR LA~HED"
appear on display.
The oven is programmed to clean
for 3 hours, but you may change the
cleaning time to to 4% hours by
first touching the CLEAR pad and
then the number pads.
"E EE" appears on display if you
enter a clean time less than
more than 41/2 hours.
Step 3:
To begin cleaning immediately,
touch START. Display shows stop
time—in this emmple, 3 hours from
the time cleaning operation starts.
No other function of the Conventional
Oven can be used until the self-
cleaning cycle is over and the oven
door is unlatched. You may use
the Microwave Oven during
cleaning time.
latched and ST~ is prtised. You
stop when the citing cycle ends.
To delay start of cleaning:
Step 1:
Repeat steps 1 and 2.
Step 2:
Touch STOP TIME pad and number
pads for the time of day you want
cleaning to be finished.
or
11/2
Display shows the time you
programmed oven to stop cleaning,
"OVEN DOOR LATCHED:'
(continued nextpage)
25