Econo Cool Operation - Mitsubishi Electric R410A Operating And Installation Instructions

Air flow velocity and direction adjustment
Enable the airflow not to blow to you directly.
To change airflow direction
Press button, two seconds
later, the horizontal vane moves to
horizontal position reversely.
Horizzontal Position
Note:
If you press button to enable the airflow not to blow to you directly, the compressor of the air conditioner will stop to operate
·
for three minutes during operation of the air conditioner.
The air amount of the air conditioner will reduce until the compressor is going to be operated again.
·
■Press button to change airflow direction (left/right).
Each press of the button enables the unit to change the vertical vane angle following the order of
Blow with swing.
Blow with swing enables the airflow to reach each corner of the room.

Econo Cool operation

Enable this mode to enjoy healthy, comfortable and power-saving cooling operation.
Please operate as follows in manual cooling mode
Prees button.
Select the air conditioner operating in
according to the outlet temperature.
Moreover, the set temperature increases by 2℃ automatically based on cooling operation.
When quitting Econo Cool operation
Press button again.
·In Econo Cool operation, press
ON/OFF button can be used further.
·Airflow speed button, Extreme Hot or Extreme Cold button and Timing ON/OFF button can be used continuously.
What is Econo Cool?
Swinging airflow (variable flow) feels cooler than constant airflow, therefore, even if the set temperature is set to a higher one
by 2℃ you can feel comfortable and power is saved.
When to use the function?
You can use the function to
prevent the airflow leaving the
indoor unit from blowing to you
directly.
The airflow may blow to you
·
directly due to special room
contour.
Press button again to enable
·
the vane to return to the previous
set position.
(Swing)
(Econo Cool) control mode, which controls the horizontal vane to swing periodically and automatically
button or change operation mode to quit Econo Cool button, or button and Timing
Cooling/Dry
The vane moves to the horizontal
position, three minutes later, the
air conditioner begins to operate
in Cool or Dry mode.
Press button again to enable
·
the vane to return to the previous
set position. About three minutes
later, the air conditioner begins to
operate in Cooling or Dry mode.
38
Heating
The vane moves to the horizontal
position, three minutes later, the
air conditioner begins to operate
in Heating mode.
Sometimes the air above the
·
groud is not hot dnough. Set the
horizontal vane to position Auto
or blow down.
Press button again to enable
·
the vane to return to the previous
set position. About three minutes
later, the air conditioner begins to
operate in Heating mode.