Installing The Infant Restraint Without Base Using Vehicle Belt (Alternate Method); Choosing An Appropriate Vehicle Seat Location - Graco SnugRide Classic Connect 35 Owner's Manual

7.2 Installing the Infant Restraint Without Base
Using Vehicle Belt
You must carefully follow the instructions provided by your vehicle
manufacturer, in addition to the information in this manual. Before
proceeding be sure you have read and understood section 6, "Choosing
an Appropriate Vehicle Seat Location" on pages 26-32.
Make sure vehicle is on level ground
so that the level indicator, which is attached
to the infant restraint, can be used to properly
recline the infant restraint.
If a front passenger seat is used (see air bag
warning, page 4), slide the vehicle seat
rearward as far as possible from the
dashboard. If a rear seat is used, make sure
the seat in front of it is moved forward enough
and is upright enough to allow room for the
infant restraint.
1. Place the infant restraint without base in a
rear-facing position in a vehicle seat.
2. Thread only the vehicle lap belt under both
vehicle belt hooks
3. Lift shoulder belt over handle and
around the back of carseat as
shown. Slide shoulder belt into the
shoulder belt guide as shown
(Alternate Method)
. Fasten the vehicle belt.
.
35
Lap/Shoulder
Belt