Installing The Infant Restraint/Base Using Vehicle Belt - Graco SnugRide Classic Connect Owner's Manual

6.3 Installing the Infant Restraint/Base
Using Vehicle Belt
You must carefully follow the instructions provided by your vehicle
manufacturer, in addition to the information in this manual. Before
proceeding, be sure you have read and understood section 5.0,
"Infant Restraint Location" on p. 21-26.
Make sure vehicle is on level ground so that the level indicator, which
is attached to the infant restraint, can be used to properly
recline the infant restraint
If a front passenger seat is used, slide the
vehicle seat rearward as far as possible
from the dashboard. If a rear seat is used,
make sure the seat in front of it is moved
forward enough and is upright enough to allow
room for the infant restraint.
1. Remove infant restraint from base,
regardless of whether or not you plan on
using the base.
.
31