Panasonic ES8249 Operating Instructions Manual page 8

Cleaning with the self-cleaning recharger (continued)
Follow the steps outlined below if the status lamp blinks or glows
during the "Clean/Dry/Charge" course or the "Clean/Dry" course.
Blinks
Correctly set the
detergent cartridge and
then restart a course.
If the status lamp goes
out
Continue a course.
When an abnormality has
been corrected
Press and hold [SELECT] for
approximately 2 seconds to
turn off the status lamp and
then restart a course.
When the status lamp
goes out
Continue a course.
8
Glows
Remove the shaver from the self-
cleaning recharger and then
check that the [CLEAN] lamp has
gone out. (Be careful as the blade
may be hot or wet.) Check that
the water tank is correctly
attached, the water tank cap is
securely closed and the self-
cleaning recharger is placed
horizontally.
When no abnormality was
found
It is time to replace the
detergent cartridge and
cleaning liquid inside the water
tank.
Drain the old cleaning liquid
inside the water tank and then
refill it with water. Replace the
old detergent cartridge and
then restart the course.
When the status lamp glows
again
Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
We recommend that you clean your
shaver with the self-cleaning
recharger or the "sonic" vibration
turbo-cleaning mode when the
faucet symbol appears on the
LCD panel.
1. Disconnect the power cord from
the shaver.
2. Apply some hand soap and some
water to the outer foil.
3. Press the OFF/ON switch for
more than 2 seconds to activate
the turbo mode for "sonic"
vibration cleaning.
•
appears on the LCD panel.
•
After about 20 seconds, it will be
automatically turned off, or you
can turn it off by pressing the
OFF/ON switch.
4. Remove the system outer foil and
press the OFF/ON switch for
more than 2 seconds to activate
the turbo mode for "sonic"
vibration cleaning and clean it
with running water.
5. Wipe off any drops of water with a
dry cloth.
6. Remove the system outer foil to
allow it to dry completely.
7. Lubricate the shaver.