Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Swift M6001CL
Summary of Contents for Swift M6001CL
-
Page 2: Led Replacement
LED REPLACEMENT Eyepiece The Swift M6000CL base is equipped with a 3.4 volt, .06 watt illumination system. The LED for this illumination system has approximately 50,000 hours of service. The time may vary depending on use and intensity. To prolong the life of the LED, you should always turn off the unit when not in use. -
Page 3: Components Of The Microscope
COMPONENTS OF THE MICROSCOPE maintenance, but certain components should be cleaned frequently to ensure ease of viewing. The power switch should also be turned off or unplugged when the microscope is not in use. ARM – the vertical column (attached to the base) which supports the stage and contains the coarse and fine adjusting knobs and focus CLEANING –... -
Page 4: Care And Cleaning
Limited Lifetime Warranty will be null and void if the mechanical or mounted below the condenser. It has multiple leaves similar to a optical components are disassembled by a non-Swift dealer. camera shutter. By moving the control lever from side-to-side, the opening in the diaphragm increases or decreases, allowing the user to PROBLEM –... -
Page 5: Digital Photography
1000 times the NA. This rule of NA x 1000 is true of all achromatic objectives. CAUTION – Never disassemble mechanical or optical components. This servicing should only be done by an authorized Swift technician. The... - Page 6 It is essential to thoroughly clean the objective switch on. Rotate the nosepiece to place the lowest power tip after use. Please contact Swift Optical or your authorized Swift objective (4XD) into position over the specimen. Be sure the dealer for the appropriate immersion oil to use.
Need help?
Do you have a question about the M6001CL and is the answer not in the manual?
Questions and answers