Finding The Viewing Channel - Philips DVDR7250H05 Service Manual

EN 16 5. 3139 785 31800
2
Set up
A

Finding the viewing channel

Presss STANDBY-ON on the recorder.
A
The recorder will display 'IS THE TV ON?'.
B Turn on the TV.
You should see the { EASY SETUP } menu.
Note If your VCR is connected to this recorder,
ensure it is turned off or in standby before proceeding.
In case you don't see the recorder's setting menu,
C
press the Channel Down button on the TV's remote
control repeatedly (or AV, SELECT, ° button) until
you see the menu. This is the correct viewing
channel for the recorder.
B
Start basic setup
Use the recorder's remote control and follow the on-
screen instructions to complete the installation.
Select the desired menu language, your country and
A
the TV shape.
Note Select { Done } in the menu and press
to the next screen.
Activate automatic channel search for analogue and
B
digital tuner/radio.
Check the date and time and press
C
To continue with the GUIDE Plus+ installation,
D
select { Continue } and press
Otherwise, select { Do not install now } and press
. Wait until the recorder has finished initialising
the system, then press
C
Install the GUIDE Plus+ system
Follow the on-screen instructions to select your
A
language, country and enter the postal code of your
area.
Note If no or wrong postal code is entered, it will
cause no GUIDE Plus+ (EPG) service information.
Jeanne van Woerkom electra
Directions For Use
to go
.
.
again.
www.freeservicemanuals.info
D
Install the set-top box
If you do not have a set-top box, skip 'D' and go to 'E'.
Press � down to select 'External Receiver 1' and
A
press .
Press again to continue.
B
Select the type of reception, service provider and
C
brand name of the connected set-top box.
Note Press to go to the next screen. Select
{ None } if none of the entries are applicable.
D Select the recorder socket through which your set-
top box is connected (e.g. 'EXT2' for EXT2 AUX-I/O
socket) and press .
Turn on your set-top box and select channel
E
number 02 on the set-top box.
Read the instructions on the TV and press
F
Setup External Receiver 1
Has the External Receiver 1 changed to
Programme Number 101?
G If the set-top box has switched to the same
programme number as displayed on the TV, select
{ Yes } in the menu and press
Note If not, select { No } and press
different code.
Your set-top box is now installed. Press the green
H
button to exit.
Note To switch the GUIDE Plus+ system's host
channel manually, go to { Host Channel Setup }.
E
Load the TV listing data
Press GUIDE to exit GUIDE Plus+ system.
A
Leave the recorder in 'standby' mode and turn 'on'
the set-top box overnight to collect the TV listing
data, this may take up to 24 hours.
Note If you tune to your Host Channel before going
to 'standby' mode, this recorder will start downloading
the TV listings data immediately.
B Check the { Editor } screen the next day to ensure
the source and programme numbers are matching
for all channels.
.
.
to try a