Oregon CS250 Original Instruction Manual page 19

OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250
CHARGING THE BATTERY PACK
WARNING: FAILURE TO FOLLOW
PROPER CHARGING PROCEDURES
MAY CAUSE EXCESSIVE VOLTAGE,
EXCESSIVE CURRENT FLOW, LOSS
OF CONTROL DURING CHARGING,
LEAKAGE OF HAZARDOUS
CHEMICALS, HEAT GENERATION,
BURSTING, OR FIRE.
With the charger cord connected to the
charger and plugged into an electrical
outlet, align the grooves in the battery
with the rails on the charger and slide the
battery pack onto the charger until fully
seated (Fig 11)
FIG. 11
Check the charge-state indicator for
charging conditions
AD 0213 - F/N 551309
OPERATING THE SAW
INSERTING AND RELEASING
THE BATTERY PACK
Only use the OREGON® brand battery
packs specified in these operating
instructions
Align the groove in the battery with the
rails inside the battery port Firmly insert
the battery pack into the chain saw's
battery port, pressing forward until it
clicks as it locks into place (Fig 12)
FIG. 12
To remove the battery pack, lift up on
the battery release and remove the pack
(Fig 13)
FIG. 13
19