Operating The Saw; Battery Pack And Charger - Oregon CS250 Original Instruction Manual

OPERATING THE SAW

OPERATING THE SAW

BATTERY PACK AND CHARGER

WARNING: DO NOT CHARGE THE
BATTERY PACK IN THE RAIN.
BATTERY PACK LED CHARGE-LEVEL
INDICATOR
The lithium ion battery pack is equipped
with an LED charge-level indicator To test
the charge level of the battery pack, press
the indicator button on the battery pack's
face (Fig 8)
No lights: recharge
One steady green light:
less than 25% charged
Charge battery pack before use
Two steady green lights:
26–50% charged
Three steady green lights:
51–75% charged
Four steady green lights:
76–100% charged
FIG. 8
INDICATOR BUTTON
INDICATOR LIGHTS
CONNECTING THE CHARGER
Connect the charger cord to the charger
and to the proper electrical outlet (Fig 9)
FIG. 9
18
OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250
Only use the cord set that was supplied
with the charger At first use, verify that
the plug type matches the receptacle
CHARGER LED CHARGE-STATE
INDICATOR
The battery charger is equipped with an
LED charge-state indicator that indicates
the state of charging as well as conditions
that may delay or prevent charging
(Fig 10)
Note: Until a battery pack is inserted, no
lights will be visible
Blinking orange/red light: a
fault condition exists There are
several potential causes See
"Troubleshooting" in this manual
Steady orange/red light: the
battery pack temperature is
beyond the acceptable range
(0°C/32°F to 40°C/104°F) Allow the
battery pack to reach the
acceptable temperature range
before charging The pack may be
left on the charger as the
temperature adjusts Charging will
begin when the proper
temperature is reached
FIG. 10
Blinking green light: battery pack
is charging
Steady green light: battery pack is
READY FOR USE
AD 0213 - F/N 551309