Grass Catcher Assembly - Ryobi 11A-545D034 Operator's Manual

Attaching Rear Wheels
• Remove hardware from hardware pack.
• Insert shoulder screw through wave washer, flat
washer, rear wheel, and spring washer.
• Secure shoulder screw with hardware to rear pivot
bar. See Figure 5.
Spring Washer
Wave Washer
Shoulder
Screw
Flat Washer
Figure 5
Attaching Starter Rope
• The rope guide is attached to the right side of upper
handle. Loosen the wing nut which secures the
rope guide. See Figure 6.
Starter
Rope
Rope
Guide
Figure 6
• With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the starter rope out of the
engine. Release the blade control handle. Slip the
starter rope into the rope guide. Tighten the wing
nut.

Grass Catcher Assembly

NOTE: Make certain the grass bag is turned right side
out before assembling (warning label will be on the
outside).
1. Frame Assembly
2. Bag
3. Hardtop Cover*
4. Mounting Bracket *
5. Two self Tapping Screws*
*Hardtop Cover only.
Assembling Soft Top Grass Catcher
• Place the bag over the frame (black plastic side is
the bottom of bag). Slip the openings in the side of
the plastic channels on the bag over the hooks on
the grass catcher frame.
•
Rear Wheel
Attaching Hardtop Cover
•
Upper Handle
Wing Nut
•
Lower
Handle
8
Secure bag to frame by working the plastic
channels on bag over frame as shown in Figure 7B.
All of the plastic channels except the center top of
the bag attach from the outside of bag. The center
top of the bag attaches from inside the bag.
A
Frame
Assembly
Figure 7
Slide the hardtop cover under the grass catcher
handle, positioning it so the handle rests snugly into
the notch in the cover, and press the frame into the
tabs at the back of the cover.
Position the mounting bracket facing down
between the front of the handle and the front of the
hardtop cover so that the holes in the cover line up
with the holes in the bracket. Insert the self tapping
screws down through the hardtop cover and
mounting bracket. See Figure 8.
Notch in
Hardtop
Cover
Mounting
Bracket
Figure 8
Plastic
B
Channels Frame
Hook
Bag
Plastic
Channels
Grass
Catcher
Handle
Self Tapping
Screws