Messages On The Display - Panasonic DMP-BBT01 Operating Instructions Manual

Blu-ray disc player
Hide thumbs Also See for DMP-BBT01:
Table of Contents

Advertisement

DMP-BBT01GN-VQT3X48_mst.book 39 ページ 2012年3月27日 火曜日 午後7時41分
Red lights up
Red lights up
Red lights up

Messages on the display

Cannot play.
You inserted an incompatible disc.
Cannot play on this unit.
You tried to play a non-compatible image.
No disc inserted.
The disc may be upside down.
$ This operation is not available.
Some operations are unsupported by the
unit. For example;
– BD-Video: During playback, reverse slow
motion or reverse frame-by-frame is not
possible.
The unit is hot.
If the maximum operating temperature is
Lights up
exceeded the unit automatically switches to
standby.
In this case turn the unit off for approximately
30 minutes and make sure that there is adequate
air flow around the unit.
The copyright protected disc cannot be played
Lights up
back since the device, such as TV, amplifier, etc.,
connected to the main unit via the HDMI cable is
not supporting the copyright protection.
Blinks
The disc in use cannot be played back since the
copyright information is invalid.
Lights up
IP address is not set.
The "IP Address" in "IP Address / DNS
Settings" is "---. ---. ---. ---". Set the "IP
Address", "Subnet Mask", and "Gateway
Address". (Select the automatic address
acquisition if necessary.)
The wireless access point currently has a low
network security setting. It is recommended
to change to a higher setting.
Authentication type for the wireless LAN is
set to "Open system", or the encryption type
is set to "No encryption". It is recommended
to encrypt for safety reasons. For details,
refer to the instructions of the wireless router
being used. Encryption is required when
playing back video, etc., from DLNA
compatible devices.
39

Advertisement

Table of Contents
loading

Table of Contents