Messages On The Front Panel Display - Panasonic DMR-HWT250 Operating Instructions Manual

Messages on the front panel display

The following messages or service numbers appear on the
front panel display when something unusual is detected.
CONV
Selected titles in the USB HDD are being converted.
Do not disconnect the USB HDD from this unit.
GUIDE
TV Guide data is being downloaded.
HARD ERR
If there is no change after switching the unit to standby mode
and turning it on, consult the dealer.
PLEASE WAIT
• Displayed when the unit is started and is switched to
standby mode.
• There was a power failure or the AC plug was disconnected
while the unit was on. The unit is carrying out its recovery
process. Wait until the message disappears.
PROG FULL
There are already 32 timer programmes. Delete unnecessary
timer programmes. ( 32)
REMOVE
The USB device is drawing too much power. Remove the
USB device.
SET
("∑" stands for a number.)
The remote control and main unit are using different codes.
Change the code on the remote control. (
START
Update of the software (firmware) is started. You cannot
operate the unit until the update is complete. (
SW-DL
Software (firmware) is downloading.
Download will stop when the unit is turned on, or the timer
recording starts. ( 75)
UNSUPPORT
The media is not supported.
UPD /
("∑" stands for a number.)
The software (firmware) is being updated. You cannot
operate the unit until the update is complete. (
U59
The unit is hot. The unit switches to standby for safety
reasons. Wait for about 30 minutes until the message
disappears.
Install or place this unit with good ventilation.
U61
A malfunction has occurred. The unit is trying to restore to the
normal operation. Once the message disappears you can use
the unit again. If it remains displayed, consult the dealer.
U76
HDMI cannot be output because it is connected to a model
that does not support copyright protection.
U99
The unit fails to operate properly. Press [Í/I] on the main unit
to switch the unit to standby mode. Now press [Í/I] on the
main unit again to turn the unit on.
X HOLD
The HOLD function is activated. (
H or F
("∑" stands for a number.)
There is something unusual. (The service number displayed
77)
after H and F depends on the unit's condition.)
Reset the unit as follows:
1 Disconnect the plug from the household mains socket,
wait a few seconds, then reconnect it.
75)
2 Press [Í/I] to turn the power on. (The unit may be fixed.)
Request service from the dealer. Inform the dealer of the
service number when requesting service.
Troubleshooting
75)
76)
83
SQT0816