Before Requesting Service - Panasonic NN-SE792S Operating Instruction And Cook Book

Before Requesting Service

The oven causes
interference with my TV.
Steam accumulates
on the oven door and warm air
comes from the oven vents.
I accidentally ran my microwave
oven without any food in it.
PROBLEM
Oven will not turn on.
Oven will not start cooking.
When the oven is turning on,
there is noise coming from
Glass Tray.
The word "LOCK" appears in
the Display Window.
The word "DEMO MODE"*
appears on the screen.
"H97", "H98" or "H00"
appears in the display
window.
* DEMO MODE is designed for retail store display. Cooking and other functions will not operate during the
DEMO MODE. If it seems there is a problem with the oven, contact an authorised Service Centre.
THESE THINGS ARE NORMAL
Some radio and TV interference might occur when you cook with
the microwave oven. This interference is similar to the interference
caused by small appliances such as mixers, vacuums, hair dryers,
etc. It does not indicate a problem with your oven.
During cooking, steam and warm air are given off from the food.
Most of the steam and warm air are removed from the oven by the
air which circulates in the oven cavity. However, some steam will
condense on cooler surfaces such as the oven door. This is normal.
Running the oven empty for a short time will not damage the oven.
However, we do not recommend this.
POSSIBLE CAUSE
The oven is not plugged in
securely.
Circuit breaker or fuse is tripped
or blown.
There is a problem with the
outlet.
The door is not closed
completely.
Start Pad was not pressed after
programming
Another program has already
been entered into the oven.
The program has not been
entered correctly.
Stop/Reset Pad has been
pressed accidentally.
The roller ring and oven bottom
are dirty.
The Child Lock was activated
by pressing Start Pad 3 times.
The microwave oven is set to
the DEMO MODE.
The display indicates a problem
with microwave generation
system.
– 20 –
REMEDY
Remove plug from outlet, wait 10
seconds and re-insert.
Reset circuit breaker or replace
fuse.
Plug another appliance into the
outlet to check if the outlet is
working.
Close the oven door securely.
Press Start Pad.
Press Stop/Reset Pad to cancel
the previous program and
program again.
Program again according to the
Operating Instructions.
Program oven again.
Clean these parts according
to care of your oven (See next
page).
Deactivate Lock by pressing
Stop/Reset Pad 3 times.
Deactivated mode by pressing
Micro Power Pad once, Start Pad 4
times and Stop/Reset Pad 4 times.
Contact the specifi ed service
centre.