Using Your Remote; Master Volume Feature - GE 11695 Instruction Manual

Using Your Remote

cbl dvd

Master Volume Feature

The Master Volume Feature allows you to select a
tv cbl
single device (TV or audio receiver) that the volume
control always controls. For example, the remote can
input
be in TV mode while the volume buttons control the
B C
volume on your audio receiver instead of your TV.
aux
menu
A B
setup
input
D
aux
setup
list
D
exit
exit
input
aux
setup
input
D
aux
setup
input
aux
input
dvd aux
setup
D
setup
Enabling the Master Volume Feature
1. Press and hold the SETUP button
C
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release desired device
button (TV, CBL, DVD, AUX) for the
device you wish to setup to always
exit
control the volume.
3. Press and release the MUTE button.
4. Press and release the VOL + button.
The red indicator will blink twice and
then go off.
To test the feature put the remote in
another mode such as the TV mode if
you programmed the audio receiver to
be the Master Volume Device. Point the
remote at the audio receiver, press and
hold either the VOL - or the VOL + button.
If the audio receiver volume changes then
the remote is programmed correctly. If
the TV volume changes and not the audio
receiver, you will have to repeat the steps
above and test again.
Disabling the Master Volume Feature
1. Press and hold the SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the device
button (TV, CBL, DVD, AUX) which is
programmed to control the Master
Volume Feature.
D
exit
10