Panasonic DMC-CM1 Lumix Basic Operating Instructions Manual page 49

How to remove the battery
When disposing of the used product, perform [Factory data reset] to completely erase all data.
This figure describes the disposal of this unit, it is not instruction for repair. If
disassembled, repair is not possible.
≥ Disassemble after the battery runs out.
≥ Wearing gloves is recommended during disassembly to prevent injury.
≥ If it cannot be removed smoothly, contact the dealer or Panasonic.
≥ Keep disassembled parts out of reach of children.
1
Use a suction cap (commercially
available) to lift up the LCD panel,
and insert a thin object such as a
card between the panel and the unit
to remove the LCD panel.
2
Remove all screws (6) in the image
below.
≥ Use a cross-slot screwdriver
(commercially available).
3
Remove the case.
≥ Regarding the handling of used batteries
– Insulate the terminals with cellophane tape or similar.
– Do not disassemble.
4
Remove the screws (3), cover and
flexible board connectors (2), and
remove the lens tube module A.
5
Remove the flexible board connectors
(3), and remove the board B.
6
Insert a flathead screwdriver
(commercially available) into the
slot antenna holder C, lift up the
antenna holder D and remove it,
and then remove the battery.
(ENG) SQT0882
Others
49