Neutral Adjustment - Scag Power Equipment SWZU36A-15KA Operator's Manual

C. 4" Position - baffle is installed using the bottom set of
holes on the front baffle welded inside the cutter
deck. (See Figure 8). Placing the baffle in the 4"
setting will enhance fall cutting (leaf pickup) and
reduce cutter deck "blowout".
To Adjust the Custom-Cut Baffle height:
1. Remove the hardware securing the Custom-Cut Baffle
to the cutter deck (See Figure 5).
-NOTE-
Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on the cutter deck size.
MOUNTING
HARDWARE
Figure 5. Custom-Cut Baffle
2. Move the Custom-Cut Baffle to desired position. (See
Figures 6 through 8 for position).
3. Reinstall the mounting hardware as shown. (See Figures
6 though 8). Torque hardware to 39ft.lbs.
TOP SET OF HOLES
FOR 3" SETTING
Figure 6. 3" Custom-Cut Baffle Position
MOUNTING
HARDWARE
2004 CCB
CARRIAGE BOLT
2004 CCB - 3" Setting
ELASTIC STOP
NUT
11
MIDDLE SET OF HOLES
FOR 3-1/2" SETTING
Figure 7. 3-1/2" Custom-Cut Baffle Position
BOTTOM SET OF HOLES
FOR 4" SETTING
Figure 8. 4" Custom-Cut Baffle Position

NEUTRAL ADJUSTMENT

-NOTE-
Neutral has been set by your Scag dealer at the
time of setup and normally does not need to be
adjusted. If, however, you find that neutral has
come out of adjustment, follow the procedure
below.
1. Raise the drive wheels off the ground and block the
caster wheels to prevent the machine from moving.
2. Make sure the speed control lever is in neutral, the
steering control levers are in the neutral latch
position, and the parking brake is on. Start the
engine.
3. Release the parking brake and note if the tires are
rotating.
CARRIAGE BOLT
2004 CCB - 3-1/2" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2004 CCB - 4" Setting
ELASTIC STOP
NUT