Temporary Program Override; Manual Operation - Robertshaw 7610 User Manual

110-1060.qxd
3. Press PROG/MAN button
until indicator is in PROG position.
PROG
MAN
SET PROG/MAN COOL-OFF-HEAT
NOTE: O
NCE THE THERMOSTAT TURNS THE SYSTEM OFF WHILE IN COOL MODE
), -
PUMP SYSTEM A BUILT
. N
COMPRESSOR O ADDITIONAL TIME DELAY RELAY
,
FOR INSTALLATION PRESS

Temporary Program Override

To temporarily increase or decrease temperature:
Press § or ¨
PROG
MAN
SET PROG/MAN
The thermostat will automatically return to the program at the next
scheduled setting change.

Manual Operation

1. Press PROG/MAN until indicator is in MAN position.
PROG
MAN
SET PROG/MAN
2. Press § or ¨ to adjust temperature settings.
Reset
To reset the thermostat to factory pre-programmed
conditions, press the reset button located directly
above the wiring terminal block.
3/27/03 10:51 AM
AUTO - ON
IN DELAY KEEPS THE COMPRESSOR FROM TURNING ON FOR ABOUT
(
DELAY ON BREAK
RESET. T
HIS WILL ERASE THE DELAY AND CHANGE PROGRAMMING TO FACTORY PRE
COOL-OFF-HEAT AUTO - ON
T PROG/MAN
COOL-OFF-HEAT AUTO - ON
RESET
Clears all memory
Page 8
ET PROG/MAN
PROG
MAN
(
COOL AND HEAT FOR SINGLE STAGE HEAT
5
MINUTES
) . T
IS NECESSARY OP OVERRIDE THE
PROG
MAN
8
(Black plate)
. T
HIS PROTECTS THE
5-
MINUTE DELAY
- .
SETS