Advertisement
Step 2—Installing the IEEE-1394b card
1.
Install the IEEE-1394b card (1) in the selected PCIe expansion slot.
2.
Lower the expansion slot retention clamp and close the retention clamp lever (2).
Figure 2
Step 3—Configuring the cabling
1.
Connect the male end (labeled P1) of the SATA power extension cable to the workstation optical
drive power supply, according to the following workstation series:
For the HP Z400 workstation, use the connector labeled P8
●
For the HP Z600 and Z800 workstations, use the connector labeled P5
●
2.
If the P5 or P8 connectors were used by another optical drive device, connect the center connector
(labeled P2) of the SATA power extension cable to the optical disk drive needing power. Route or
tie excess cable to ensure it does not interfere with system fans.
3.
Connect the other end (labeled P3) of the SATA power extension cable to the power connector on
the IEEE-1394b card.
Figure 3
4
IEEE-1394b PCI Express Card installation
Installing the IEEE-1394b card
Connecting the SATA power extension cable
ENWW
Advertisement
