Download Print this page
HP IEEE-1394b Installation Manual

HP IEEE-1394b Installation Manual

Pci express card

Advertisement

Quick Links

IEEE-1394b PCI Express Card
installation
Introduction
This document describes how to install an IEEE-1394b PCI Express (PCIe) card in HP Z series
workstations.
Kit contents
IEEE-1394b PCIe card
External 1394b cable
SATA power extension cable
1394b Unibrain drivers CD
Warranty information
Installation instructions
Before you begin
To view QuickSpecs and determine the compatibility of this product with your HP workstation, see
http://www.hp.com/go/productbulletin.
ENWW
© 2011 Hewlett-Packard Development Company, L.P.
Introduction
1

Advertisement

loading

Summary of Contents for HP IEEE-1394b

  • Page 1 IEEE-1394b PCI Express Card installation Introduction This document describes how to install an IEEE-1394b PCI Express (PCIe) card in HP Z series workstations. Kit contents IEEE-1394b PCIe card ● External 1394b cable ● SATA power extension cable ● 1394b Unibrain drivers CD ●...
  • Page 2: Warnings And Cautions

    — Create a common ground for the equipment you are working on by connecting the static-free mat, static strap, and peripheral units to that piece of equipment. NOTE: HP accessories are for use in HP computer products. They have been extensively tested for reliability and are manufactured to high quality standards. IEEE-1394b PCI Express Card installation...
  • Page 3: Step 1-Preparing For Component Installation

    Some workstations may have card hold-down supports installed. If any card support is present, remove it for access to the expansion slots and system board connectors. Select an appropriate PCIe expansion slot and remove the slot cover. The IEEE-1394b card may be installed in any unused PCIe expansion slot.
  • Page 4 Step 2—Installing the IEEE-1394b card Install the IEEE-1394b card (1) in the selected PCIe expansion slot. Lower the expansion slot retention clamp and close the retention clamp lever (2). Figure 2 Installing the IEEE-1394b card Step 3—Configuring the cabling Connect the male end (labeled P1) of the SATA power extension cable to the workstation optical...
  • Page 5: Japanese 日本語

    Reconnect power to the workstation and all external devices. Restore power to the workstation and all external devices. Japanese 日本語 This document is available in Japanese. See http://www.hp.com/support/workstation_manuals, then select your workstation product and select Japanese from the drop down Manual Language menu.