Advertisement
2.8 INSTALLATION WITH AN INTEGRAL LE155/250 &
LE155-1/250-1 HEAT RECOVERY UNIT
NOTE: Refer to the Installation, Commissioning and Servicing
Instructions provided with the heat recovery unit and fit in the
predetermined position above the cooker. DO NOT FIT the base plate to
the heat recovery unit. This item is to be discarded!
2.8.1 Remove the grille from the cooker hood allowing access to the
screw positions on the inside of the unit.
2.8.2 Using the screw positions where the base was fitted, fix the
cooker hood.
2.8.3 Connect the cooker hood to the heat recovery unit in
accordance with the heat recovery unit instructions.
2.8.4 Reconnect the grille to the cooker hood and close.
FIGURE 2
Cooker Hood Positioning
HR Unit Integral with
Cooker Hood
3. COMMISSIONING
3.1
Switch on the electrical supply to the unit.
3.2
Switch on the heat recovery unit and ensure that air is being drawn
through the cooker hood. (Measure airflow at the damper position with
the grille removed.)
3.3
Switch the lamp ON, to ensure that both lamps illuminate.
Telephone: 01604 762881
Slim Line
H
Cooker Hood
Advertisement
