Absima CR4T User Manual page 36

w) RX setup
This feature allows you to program the receiver. The following
setting options are at your disposal:
„Bind with a receiver":
Select this when the radio control will be connected to a receiver
again.
„RX battery monitor":
This feature displays the following information of the receiver
battery:
„External sensor":
Activate this feature if you use an external sensor. This is
especially useful if the receiver is powered available via an
electronic speed controller with power. Connect therefor the
sensor directly to the main battery.
„Low voltage":
Here you set the minimum voltage stand for a nearly dead battery.
Picture 34
„Alarm voltage":
Set here, when the product is to issue an audible alarm when a certain voltage is reached.
„High voltage":
Here you set the maximum voltage stand for a fully charged battery.
Select therefor the parameter to change. Move the controller to the right or left to adjust the value according to your
wishes. Tap the button "back" in order to save the changes and return tothe menu.
„Failsafe":
This feature allows you to program the servo position, wich can be adjusted automatically in case of loss the signal
from the transmitter. If the setting to "Off" position, the servos remain with signal loss in their last position.
To change the values of the individual servo positions:
„Steering" aktivieren:
Tap the button "activate / deactviate". Move the controller to the right or left to adjust the value according to your
wishes. Tap the button "back" in order to save the changes and return tothe menu.
„Steering" deaktivieren:
Select the function "steering". Tap the button "activate / deactivate" to deactivate the set value.
36