Table of Contents
Advertisement
Installation
1. Remove the activation strip from the battery
compartment.
2. Remove the backing paper from one side of each
double-sided adhesive strips. Fix one adhesive strip
to the back of the Magnet and one to the back of
the Transmitter (alternatively for permanent fixing
use the screws supplied).
3. Peel off the other side of each adhesive strip.
Mount the Magnet on the door and the
Transmitter on the door frame (small triangles
facing each other), with less than a 6mm
separation between the two.
4. When opening the door a small red indicator
lights up briefly, this indicates that the
Transmitter has sent a signal to the Control Panel.
LED
Specification
DC 1.5V (AA 1.5V LR6 Battery x 1pc)
Power Supply
Static Current
≤ 30uA
Transmitting Distance
Radio Frequency
Housing Material
Operating Temperature
Relative Humidity
Sensor Dimensions (LxWxD)
Magnet Dimensions (LxWxD)
LED
≤ 40mA
Alarm Current
≤80m ﴾in open area﴿
433MHz
ABS Plastic
-10°C~55°C
≤ 80% ﴾non‐condensing﴿
71 x 34 x 17.5mm
51 x 12 x 13.5mm
3. REMOTE CONTROL
Features
The Remote Control enables you to quickly and
conveniently Arm and Disarm your Alarm System.
In the event of an emergency when in or near your
property, pressing the SOS button will trigger an
alarm condition on the Control Panel/Siren.
Appearance
LED Indicator
Arm
Part Arm *
(Home Mode)
* Note: Part Arm Function does not work
with Siren Controlled Alarm Systems
LED Indication
Flashes once:
transmits the signal
Low Light Level:
low battery indication, (immediate
battery change recommended)
Buttons/Functions
See over.
Specification
Power Supply
Transmitting Distance
Radio Frequency
Housing Material
Operating Temperature
Relative Humidity
Dimensions (L x W x D)
Disarm
Panic
Key-ring Clasp
DC3V CR2025 Lithium Battery
≤80m ﴾in open area﴿
433 MHz
ABS Plastic
-10°C~50°C
≤ 80% ﴾non‐condensing﴿
58 x 31 x 9.5mm
Advertisement
Table of Contents
