Operating instructions hawos Novum Congratulations on purchasing your hawos flour mill!
Page 2
– risk of injury! Before opening the housing, be absolutely sure hawos flour mills are equipped with an overcurrent to pull the mains plug to prevent the unit from circuit breaker that protects the motor from accidentally activating –...
It will 1. Mill feed reward you with reliability and convenience. Please only use clean and dry grains. You can...
Page 4
After you have connected the mill to the power setting. Cause: Despite a high degree of precision, supply, your hawos is ready for operation. Place a the threading for the fine setting always has to have bowl under the flour outlet and set the desired a small amount of play.
Page 5
Faults Mill feed table Mill feed Setting from the level Feel free to also try foods that Wheat can be rolled and those that 1.5–2 can be poured that are not Spelt 1.5–2 indicated on the adjacent Barley table, e. g. dry spices. Oats Millet Proceed with care when trying...
Page 6
Störungen The mill turns off while in use: Debris or Figure 1 clogged grindstones may cause the mill come to a Unscrew the standstill. In such a case, the overcurrent circuit adjusting lever. breaker automatically deactivates the mill after approximately 20 seconds. Figure 2 Solution: Remove the...
Page 7
Öffnen des Mahlwerks Figure 6 Opening the grinder Unscrew the Attention! Turn off the mill with the On/Off top grindsto- switch and then disconnect the mains plug ne by turning before opening the housing to prevent the device it counter- from accidentally turning on –...
Service If you have questions about your mill, please give us a call or write us an e-mail, our customer service team is happy to assist you. Tel.: +49 (0) 6172 401200 • E-mail: info@hawos.de Strong Mills – Fine Flour hawos Kornmühlen GmbH...
Need help?
Do you have a question about the Novum and is the answer not in the manual?
Questions and answers