Table of Contents
Related Manuals for Kärcher HD 7/16-4 ST
Summary of Contents for Kärcher HD 7/16-4 ST
- Page 1 HD 7/16-4 ST HD 7/16-4 ST-H HD 9/18-4 ST HD 9/18-4 ST-H HD 13/12-4 ST HD 13/12-4 ST-H Deutsch English Français Italiano Nederlands Español Português Dansk Norsk Svenska Suomi 59637700 08/14...
-
Page 2: Table Of Contents
Please read and comply with Safety instructions Hazard levels these original instructions prior DANGER – Please follow the national rules and to the initial operation of your appliance and Pointer to immediate danger, which leads regulations for fluid spray jets of the re- store them for later use or subsequent own- to severe injuries or death. -
Page 3: Proper Use
If the operating time (without interruption of Proper use Water quality requirements work) exceeds an adjustable value (5...120 ATTENTION – This equipment produces water under minutes), the appliance will shut off. Only clean water may be used as high high pressure downstream to high pres- Motor protection switch pressure medium. -
Page 4: Function
Function Flow pattern 1 Solenoid valve water supply (upgrade consisting of 1 detergent pump (23.1), Automatic pump start kit, optional) and 1 detergent level sensor (23.2) If the system pressure sinks during the 2 Water inlet 24 Detergent dosing, double under high standby period due to the opening of one of 3 Swimmer valve pressure (upgrade kit, option), consist-... -
Page 5: Device Elements
Device elements Operation Operating elements Appliance cover removed. Safety instructions The operator must use the appliance cor- rectly. When working with the appliance, he must consider the local conditions and pay due care and attention to other persons, in particular children, who are nearby. Never leave the appliance unattended when it is in operation. -
Page 6: Transport
High pressure operation Interrupting operation Remove the appliance cover Note: Release the lever of the trigger gun; the Unscrew the fastening screw of the ap- The appliance is equipped with a pressure device will switch off. pliance cover. switch. - Page 7 Safety inspection/ maintenance contract You can sign with your dealer a contract for regular safety inspection or even sign a maintenance contract. Please take advice on this matter. Maintenance schedule Time Activity Assembly affected Performance of whom daily Check hand- Hand spray gun Check whether the hand-spray gun closes tightly Operator...
-
Page 8: Troubleshooting
– Risk of chemical burns on account of Troubleshooting Maintenance contract acid! Wear protective glasses and pro- In order to guarantee a reliable operation DANGER tective gloves. og the equipment, we success, you signed Risk of electric shock. Note: a maintenance agreement. Please refer to Risk of injury! Switch off the power switch –... - Page 9 Fault Possible cause Remedy of whom Water stream is uneven. Nozzle is blocked. Clean the nozzle. Operator Amount of water supply is too low. Check water supply. Operator Inadequate or no flow of de- Dosage adjusted too low. Increase dose. Operator tergent Nozzle is set to "High pressure".
-
Page 10: Technical Specifications
Technical specifications HD 7/16-4 ST HD 9/18-4 ST HD 13/12-4 ST HD 7/16-4 ST-H HD 9/18-4 ST-H HD 13/12-4 ST-H Electrical connection Voltage Current type Frequency Connected load Electrical protection (slow) Type of protection IPX5 Power supply Water connection Min. feed volume... - Page 11 Specifications sheet A Water inlet 3/4" E On rack B High pressure output M 22x1.5 C Electrical connection from the bottom D Wall mount...
-
Page 12: Accessories
Accessories Detergent Detergents simplify the cleaning tasks. The The following types of detergent are not table gives a selection of detergents. suitable because they damage the Please read the instructions on the packag- equipment. ing carefully before working with any deter- –... - Page 13 Attachment sets Remote controls Upgrade kit, remote re- 2.637-491.0 1 operating point. Restoring the operation readiness after the readiness period has lease* elapsed. Several operating stations can be used parallelly. Upgrade kit for remote con- 2.744-014.0 1 operating point. Actuation of the high pressure pump and up to two detergent. Use trol, HD simple* of 2 operating stations or one operating station and one coin remote control (item 3) in connection with the priority switch (item 4).
-
Page 14: Installing The Plant
Installing the plant Water supply Install the detergent tank – Design the water supply for continuous The detergent tank is set up in such a way, Only for authorised techni- operations. that the bottom of the tank is located not cians! –... -
Page 15: Ec Declaration Of Conformity . En
– using a hardness tester (order no. EC Declaration of Conformity Accessories and Spare Parts 6.768-004) We hereby declare that the machine de- – Only use accessories and spare parts DANGER scribed below complies with the relevant which have been approved by the man- Dangerous electrical voltage! Setting may basic safety and health requirements of the ufacturer. -
Page 16: Customer Service
Customer Service Plant type: Manufact. no.: Start-up on: Testing done on: Findings: Signature Testing done on: Findings: Signature Testing done on: Findings: Signature Testing done on: Findings: Signature... - Page 18 http://www.kaercher.com/dealersearch...