Miele KFN 12823 SD Operating And Installation Instructions page 55

Reversing the appliance doors:
^ Pull the entire bearing pin a,
including washer b and adjustable
foot c, upwards to remove.
^ Pull out the plug d.
^ Undo the screws e and remove the
hinge plate f.
^ Slightly loosen the screw of the
bearing piece h on the hinge
platef. Turn the piece into the hole
on the opposite side of the bearing
plate f and firmly tighten the screw.
^ Insert the plug d in the other hole.
^ Remove the cover g and fit it into the
holes on the opposite side.
Reversing the door hinging
^ Screw the hinge plate f into place
on the opposite side, using only the
outer slotted holes to do so. Do not
use the centre screw. Only by
keeping the centre hole free is it
possible to align the door at a later
point using the slotted holes.
^ Important! Screw the adjustable foot
c on the bearing pin a all the way
in.
^ Return the entire bearing pin a,
including the washer b and
adjustable foot c, to its proper
position. Important! The tab on the
bearing pin must still face the
appliance.
^ Lower the lower door onto the
bearing pin b.
^ Close the lower door.
55