Setup - Central Pneumatic 60567 Owner's Manual And Safety Instructions

Setup

1. Break in the new Air Compressor as follows:
a. Turn the Power Switch off and unplug the unit.
Insert a male coupler (sold separately)
into the female Quick Coupler and fully
open all regulators and valves.
b. Plug in the Power Cord.
c. Turn the Power Switch ON.
d. Let the unit run for 30 minutes.
Air will expel freely through the Coupler.
e. Turn the Power Switch OFF.
f. Unplug the Power Cord and
remove the male coupler.
checking the Oil
1. Check the oil level before operation.
Fill the Pump Crankcase with
SAE 30W, non-detergent, Air Compressor Oil.
IMpORTANT: Running the Air compressor
with no oil or low oil will cause damage to
the equipment and void the warranty.
2. The oil level should be at the center of the "full" level
on the oil level sight glass, as shown in Figure B.
Add oil as needed to maintain this level.
Do not let the oil level go below the center
dot (LOW as shown below) and do not overfill
the oil so that it is above the center dot
(OVERFILL as shown below) on the sight glass.
OVERFILL
FULL
Figure B: Oil Sight Glass
Item 60567
LOW
For technical questions, please call 1-888-866-5797.
2. Connect a regulator valve, an inline shut off valve
and a 1/4" NPT air hose to the Quick Coupler
(all sold separately). The air hose must be long
enough to reach the work area with enough extra
length to allow free movement while working.
Note: An in-line shutoff ball valve is an important
safety device because it controls the air supply even
if the air hose is ruptured. The shutoff valve should
be a ball valve because it can be closed quickly.
3. Depending on the tool which you will be
using with this compressor, you may need to
incorporate additional components, such as an
in-line oiler, a filter, or a dryer (all sold separately),
as shown on Figure C on page 8 and
Figure D on page 9. Consult your air
tool's manual for needed accessories.
3. To add oil:
a. Remove the Oil Plug.
b. Using a funnel to avoid spills, pour enough
oil into the Pump Crankcase to reach
the "full" level in the Oil Sight Glass.
c. Replace the Oil Plug.
Note: SAE 30W, non-detergent, Air Compressor Oil
is recommended for use with this compressor.
4. If uncertain which oil to use for this compressor,
call Harbor Freight Tools customer service
at 1-888-866-5797 for assistance.
5. change the compressor oil after the first
hour of use to remove any debris.
cAUTION! TO pREVENT INJURy FROM BURNS:
Do not add or change the oil while
the compressor is in operation.
Allow the compressor to cool before replacing oil.
Page 7