AT&T Voice Terminal 6434 Quick Reference Manual page 3

EXIT/NORMAL (display feature)
When you are ready to leave Display or Softkey
Mode and return to Normal (call-handling) Mode
1 Press [ ].
Exit
HOLD
To put a call on hold
1 Press [
].
Hold
To answer a new call while active on another
1 Press [ ].
Hold
2 Press call appearance button of incoming call.
To return to held call
1 Press call appearance button of held call.
INSPECT (display feature)
To see who is calling while on a call
1 Press [
].
Inspect
Call source is shown on display.
2 Press [
] to return to display for present call.
Exit
LAST NUMBER DIALED
To automatically redial the last number you
dialed
1 Press [
]
LastDialed
or Dial Last Number Dialed access code
LEAVE WORD CALLING (LWC)
To leave a message after dialing an extension
1 Press softkey below LWC
or Press [ ] before hanging up your handset.
LWC
6
To leave a msssage without ringing an extension
1 While off-hook press softkey below LWC
or Press [ ]
LWC
or Dial Leave Word Calling access code
2 Dial extension.
3 Hang up.
To cancel a Leave Word Calling message
1 While off-hook press the softkey below CnLWC
or Press [ ]
Cancel LWC
or Dial Leave Word Calling cancel code
2 Dial extension.
PRIORITY CALLING
To place a priority call (3-burst ring)
1 While off-hook press the softkey below PCall
or Press [ ]
Priority
or Dial Priority Calling access code
2 Dial extension.
RESET SPEAKERPHONE
To adjust the speakerphone to the surrounding
room acoustics
1 While on-hook, press [
press [ ].
Speaker
You hear a series of tones.
.
SELECT RING (and RINGER VOLUME)
To select a personalized ring
1
Press [ ] and then press [
Shift
Current ringing pattern plays, and pattern
number is displayed.
2 To cycle through all eight ring patterns, continue to
press (and then release) [
[ ] or [ ]).
N e x t > < P r e v
3
When you hear the desired ring pattern, press
[ ] again.
Shift
.
.
.
] and then
Shift
].
Hold
] (or press
Hold
7
To adjust ringer volume if necessary (speaker is
not active)
1 To raise the volume, press the right half of the
Volume control button labeled [
to lower the volume, press the left half of the
Volume control button labeled [
SEND ALL CALLS
To send all calls (except priority calls) immediately
to coverage
1 Press [
]
Send Calls
or Dial Send All Calls access code
To cancel Send All Calls
1 While off-hook, press [
Send Calls
or Dial Send All Calls access code
SPEAKERPHONE
NOTE: To use this feature, your voice terminal must
be set for the Speakerphone (speak and listen)
feature.
To place or answer a call without lifting the
handset, or to use speakerphone with any feature
1 Press [
].
Speaker
2 Place or answer call, or access selected feature.
3 Adjust speakerphone volume if necessary:
To raise the volume, press the right half of the
Volume control button labeled [
to lower the volume, press the left half of the
Volume control button labeled [
To prevent the other party from hearing you
1 Press [
].
Mute
Red Mute light goes on.
2 Press [ ] again to resume talking to party.
Mute
Red Mute light goes off.
8
];
]
.
] again
.
];
].