Table of Contents
Advertisement
The VF-PBM307/ AT-90 mount combination places
the center of gravity closer to the front of the
camera body and does not have as much front-aft
movement as the AT-500.
AT-90
Page 14 of 32
AT-500
The VF-PBM307/ AT-500 mount combination
shown above, places the viewfinder closer to the
camera operator and has a superior tilt range
and longer movement lock handle.
Plug in the supplied VC-J90A 20-pin Viewfinder to
camera cable by gently rotating it until it seats in
the receptacle.
Tug on the connector to make sure it is locked
and firmly seated.
OPTIONAL:
So that the VC-J90A 20-pin Viewfinder cable does
not get lost, we recommend that it be
mechanically affixed to the rear of the viewfinder
with the provided clamp. Note that the clamp
should not be over tightened to the extent of
damaging the cable. The cable should have good
mobility as the viewfinder is operated by rotating
and tilting as needed.
Advertisement
Table of Contents
