Table of Contents
Advertisement
Tighten
The AT-90 or AT-500 includes the viewfinder
locking bolt or fixing screw.
Install the supplied ¼-20 Fixing Screw on the
threaded mount on the bottom part of the
viewfinder chassis.
Secure the Fixing Screw such that it does not
easily come out. (We recommend you affix it
with some thread locking glue.)
Insert the viewfinder in the AT-90 or AT-500
bracket with the operation handle facing the
screen.
After mounting the Viewfinder on the Adapter,
move the lock level downward to secure it in
place.
Assure that the viewfinder is mechanically
fixed to the support bracket and that it does
not wobble or fall.
Mount the viewfinder and bracket assembly on
the cable adapter by first; turning the Gray
Lock ring, second by depressing the lock lever
as shown on the right.
To remove; hold on to the viewfinder and
perform the above steps again while pulling
the viewfinder away from the camera body.
OPTIONAL:
You may just insert the male wedge on the
viewfinder assembly onto the female one on
the camera body. You will hear a click and the
viewfinder will be mechanically secure.
Check by pulling the viewfinder towards the
rear of the camera so that it doesn't fall or
come off easily.
Page 13 of 32
Advertisement
Table of Contents
