Miller MIGMATIC 220 Owner's Manual page 10

Do not weld on drums or any closed containers.
Do not discard product (where applicable) with general waste.
Reuse or recycle Waste Electrical and Electronic Equipment (WEEE) by disposing at a designated collection
facility.
Contact your local recycling office or your local distributor for further information.
Disconnect input plug or power before working on machine.
Read Owner's Manual and inside labels for connection points and procedures.
Í Í
Í Í
V
?
A
?
Consult rating label for input power requirements.
Welding wire and drive parts are at welding voltage during operation − keep hands and metal objects away.
<10°
Falling unit can cause injury. Do not move or operate unit where it could tip.
3
OM-246 691 Page 6
1
Move jumper links as shown on inside label to match input voltage at
job site. Include extra length in grounding conductor and connect
grounding conductor first. Connect line input conductors as shown on
inside label. Double-check all connections, jumper link positions, and
input voltage before applying power.
Wear hat and safety glasses. Use ear protection and button shirt
collar. Use welding helmet with correct shade of filter. Wear complete
body protection.
Become trained and read the instructions before working on the
machine or welding.
Safe16 2012−05
Safe37 2012−05
Safe30 2012−05
Safe67 2012−06
Safe34 2012−05
Safe33 2012−05
Safe53 2012−05
Safe49 2012−05
Safe38 2012−05
Safe40 2012−05