The Front Panel - Optus DGN2200 Easy Manual

SAY HELLO TO YOUR
SHINY NEW ROUTER
BEFORE YOU INSTALL AND CONNECT YOUR ROUTER, TAKE A MOMENT TO FAMILIARISE YOURSELF
WITH THE FRONT AND BACK PANELS OF THE ROUTER.

THE FRONT PANEL

The wireless modem router front panel contains status LED lights. You can use the LEDs
to verify various conditions. See the table below to see what each LED means.
1 2 3 4
1 2
1. POWER,
SOLID GREEN, power is supplied to the router
FACTORY
SOLID RED, POST (Power-On Self-Test) failure or device malfunction
RESET
OFF, power is not supplied to the router
FACTORY RESET, during a reset, the lights blink red three times and then turn green as the modem resets
to the factory defaults. A factory reset will reverse any settings you've customised, e.g. it will change back to the
WiFi Network Name and Password printed on the WiFi card we sent you
2. ETHERNET
SOLID GREEN, the powered device is connected to the associated Ethernet Local Area Network (LAN) port
PORTS 1-4
BLINKING GREEN, data is being transmitted or received
SOLID AMBER, the powered device is connected to the associated Ethernet Local Area Network (LAN) port
BLINKING AMBER, data is being transmitted or received
OFF, no link is detected on this port, or modem powered off, or no cable or powered device is connected
to the associated port
3. USB
SOLID GREEN, USB device has been accepted by the Router and is ready to be used
FAST BLINK (GREEN), data is being transmitted or received over the USB link
OFF, no USB device is connected
4. DSL
SOLID GREEN, the ADSL port is synchronized with your ISP's DSL Access Multiplexer (DSLAM)
BLINKING GREEN, the ADSL is synchronizing with Optus
OFF, no link is detected on the ADSL port
5. INTERNET
SOLID GREEN, the wireless modem router is connected to the internet. The LED will remain solid green
if the internet session is dropped due to an idle time-out, but an ADSL connection is still present
BLINKING GREEN, if the session is dropped for any other reason, the LED will turn off
RED, the wireless modem router is connected to the internet and traffic is passing through the device
OFF, the wireless modem router attempted to connect to the internet but failed
The wireless modem router is powered off, in bridged mode, or there is no ADSL connection
6. WIRELESS
SOLID GREEN, the Wireless Access Point is enabled
BLINKING GREEN, data is being transmitted or received over the wireless link
OFF, the Wireless Access Point is disabled
2
3 4 5 6