Delta UNISAW 36-L31 Instruction Manual page 23

When ripping material with a veneer facing that extends
over the material, the fence (A) should be in the
horizontal position with the veneer (B) extending over
the lip of the fence, as shown in Fig. 57.
When ripping material with a veneer facing and the
material is not thick enough for the veneer to extend
over the lip of the fence or if the veneer facing (B) is on
both sides of the material, as shown in Fig. 58, the fence
can be positioned slightly above the surface of the table.
The veneer can be placed between the fence and the
table or the veneer can straddle the fence with the
material solidly against the fence, as shown.
RIPPING ON LEFT
SIDE OF SAW BLADE
In some cases it may be desirable to use the fence on
the left side of the saw blade. This is easily
accomplished by repositioning the fence (A) Figs. 59
and 60, fence clamp bar (B), and lock knobs (C) so that
the fence (A) will be attached to the right side of the
fence body, as shown in Fig. 60. The complete fence
assembly (D) Fig. 60, can easily be moved to the left side
of the saw table.
B
A
C
23
A
Fig. 57
B
Fig. 58
C
B
Fig. 59
D
Fig. 60
A