Voice Recognition
Starting Voice
Recognition
Starting Voice Recognition
Shortly press the
steering wheel remote controller
(under 0.8 seconds) ▶ Say a
command.
Once voice recognition starts, the voice
command entry window and the six rep-
resentative commands are displayed.
If voice recognition is in [Normal
•
Mode], then the system will say
"Please say a command after the
beep," followed by a beep tone.
If voice recognition is in [Expert
•
Mode], then you will only hear a
beep a "Beep~".
Skipping Prompt Messages
While prompt message is being
stated ▶ Shortly press the
the steering wheel remote controller.
(under 0.8 seconds)
The prompt message is immediately
ended and the beep tone will sound.
After the "beep", say the voice command.
Re-starting Voice Recognition
While system waits ▶ Shortly press
the
key on the steering wheel
remote controller. (under 0.8 seconds)
The command wait state will end and
the beep tone will sound. After the
"beep", say the voice command.
58
key on the
key on