Sharp XV-C100U Service Manual page 11

Top Cabinet
1-8
Reassembling procedure
1. Fit the lens cover and the side cover to the bottom panel. Tighten up the related screws.
2. Set the top cabinet over the bottom cabinet.
3. Tighten up the M3 tapping screw into the sub unit cover.
4. Press the rear cabinet against the top and bottom cabinets to fit them together.
5. Tighten up the screws into the rear cabinet. Use the six 3-mm tapping screws.
6. Tighten up the tapping screws to fix the top and bottom cabinets.
7. Put the lamp/cage module unit into position. Tighten up the two 4-mm screws.
8. Place the lamp cage cover and tighten up the screws.
1-8. Now lift the top cabinet further up and
1-9. Disconnect the connector (PE) of the AC cord
1-10. Remove the spacer.
1-11. Remove the screws off the lens Cover.
1-12. Disconnect the speaker connector (SP) and
1-10
1-9
(PE)
1-11
Lens Cover
11
disconnect the leaf switch connectors (LL) as
well as the operation key unit flat cable (KE).
The top cabinet is now free.
(that runs through the rear cabinet) from the
ballast unit. Detach the rear cabinet.
remove the three lock screws. Remove the
screw off the ground lead. Now detach the side
cover.
Rear Cabinet
1-12
XV-C100U
1-12
(SP)
Side Cover