Panasonic CS-E12RB4UW Service Manual page 34

2 Fitting the decorative panel
Temporarily secure the fixing screws (3
o
pcs.) before fitting the decorative panel.
(For temporarily securing the front grille.)
Place decorative panel on the screws (3
o
pcs.) before fitting, move decorative
panel as illustrated and tighten all the
screws (4 pcs.).

Check beforehand the height from the ceiling to
the unit.

The front grille fitting direction is determined by
the unit direction.

Only use the screws with the length of 1-3/8"
(35 mm) which is provided, to fix the decorative
panel.

Do not use other screw which is longer it may
cause damage to the drain-pan and other
components.
3 Fit the decorative panel and ceiling wall together and confirm no gap in between. Readjust indoor unit height,
if there is a gap between ceiling wall and decorative panel.
Good example
4 Open the indoor control box cover by
removing 2 pcs of screw.
5 Insert firmly the connector of cosmetic louver
to indoor pcb CN-STM1, CN-STM2 and
CN-DISP.
Be caution not to clamp the cord in between
control board and control board cover.
6 After complete, install back removed part
follow opposite procedure.
Be sure to hook the air inlet grill string,
to prevent grill from falling and causing
injury from it.
Air conditioner
unit
Air
Decorative
panel
Fit the insulator (this part) and
be careful for cool air leakage.
Hang the
string
Air inlet grille
Decorative
Panel moving
direction
Bad example
Cool air leakage
(no good)
Ceiling
Catcher
34
Securing the tentative
fixing screw
Approx. 3/4 (20 mm)
Front grille fixing
scews (4 pcs.)
Air conditioner
unit
Air
Ceiling
Decorative
panel
CN-STM2
CN-STM1
CN-DISP
Clamp lead
wire with band
here
Catcher
Piping
direction
Tighten this
screw first
after hanging
the grille
frame