Advertisement
_ 5. inSTallinG THE SEaT
noTE!
The seat may only be installed in a rear-facing position!
place the child seat on the vehicle seat and swivel the carrying handle to position
a (figure 5.1, Section 2). pass the vehicle belt around the seat (figure 5.2) and
secure the vehicle belt lock in the vehicle buckle with a clearly audible "click".
thread the lap belt through both guides. on the side of the lock, pass the
shoulder belt between the profix connector and the seat shell (figure 5.3 detail).
open the flap covering the locking mechanism on the back of the seat
(figure 5.3). insert the shoulder strap through the locking mechanism and tension
(figure 5.3). close flap.
imporTanT:
Check once again that the belt is correctly inserted in the guides as
indicated (figure 5.4). otherwise the safe functioning of the child seat
cannot be guaranteed.
The vehicle seat belt must be pulled taut and must not be twisted.
The lap and shoulder belts must not be confused.
_ 6. CHanGinG THE CoVEr anD inSTrUCTionS for CarE
To CHanGE THE CoVEr (see step-by-step guide on rear flap of the
instructions for use): in order to change the cover, first remove the shoulder
straps (fig. 6.1 and Section 4). undo the clasp (fig. 6.2). release the cover at
the front of the adjustment mechanism (fig. 6.3). Slide off the padding on the belt
and clasp (figs. 6.4 and 6.5). lift out the polystyrene tray liner and loosen the
Velcro fastener on each of the crotch belts (fig. 6.6). pull cover off forwards and
simultaneously push the clasp and the two straps down through the slits in the
cover (fig. 6.7 and 6.8).
reverse these steps to replace the cover: pull on cover and insert straps and
clasp through the slits in the cover (figs. 6.8 and 6.7). close the Velcro fastener
(fig. 6.6). position the polystyrene tray liner in the shell of the seat, tighten the
crotch belts and replace the belt padding (fig. 6.5 and 6.4).
20
attach cover to adjustment mechanism (fig. 6.3) and reposition the shoulder
straps at the correct height (fig. 6.1 and Section 4). check that the straps have
been mounted correctly (Section 4).
CarE inSTrUCTionS: the cover may be washed on a gentle cycle at 30°c.
for details, refer to the washing label on the cover. the cover fabrics can easily
fade when they come into contact with moisture, especially during washing.
do not use solvents!
_ 7. SUn SHaDE (aCCESSoriES)
the sun canopy can fitted to the concord ion using the snap fasteners (fig. 7).
the child seat may also be placed on a concord buggy and locked into
position. it can be released again by pressing the locking button on the carrying
handle.
_ GEnEral informaTion
• This is a "universal" child restraint system. It is approved for general use in
vehicles in accordance with un-ece regulation 44, amendment 04 and fits
most, but not all, passenger vehicle seats.
• It can be assumed that the system will fit correctly if the vehicle manufacturer
states in the vehicle manual that the vehicle is suitable for the installation of a
"universal" child restraint system for the relevant age group.
• This child restraint system has been classified as being of the "universal" class,
satisfying stricter conditions than previous models which do not bear this label.
• If in doubt, please consult the manufacturer of the child restraint system or the
retailer.
• Only suitable for vehicles with three-point (lap and diagonal) seat belts tested
and approved in accordance with un-ece regulation 16 or a comparable
standard.
21
Advertisement
