Advertisement
adjustment button for carrying handle
polystyrene inlay and cover
infant insert
carrying handle
locking button for buggy
belt and buckle padding
locking mechanism
connecting piece
belt buckle
belt adjuster
adjusting strap
Seat shell
Seat insert
belt guide
_ 2. aDjUSTinG THE CarryinG HanDlE
the carrying handle may be adjusted to four positions (figure 2.1):
a = installation position
b = carrying position
c = rocking position
d = resting position
to adjust the carrying handle, press the adjustment button in the direction of
the arrow and swivel the handle to the required position (figure 2.2). the handle
automatically clicks into positions b, c and d.
_ 3. SECUrinG THE CHilD
looSEninG THE BElTS: press the button on the belt adjuster and at the same
time pull the shoulder belts forwards (figure 3.1).
opEninG oUT THE BElTS: open the belts by pressing the red button on the
belt buckle. open the shoulder belts outwards to lie over the side of the seat and
lay the crotch belt over the seat front (figure 3.2).
18
SEaTinG THE CHilD anD faSTEninG THE loCk: after seating the child,
pass the belts over the child's shoulders, fit both lock tongues together and push
them into the belt buckle so that they engage with an audible "click" (figure 3.3).
The belts must not be twisted!
TEnSioninG THE BElTS: pull the adjusting strap in the direction of the arrow
until the belts are positioned tautly across the child's body (figure 3.4).
_ 4. fiTTinG
BElT SySTEm: the belt system may be adjusted in three ways to fit the size of
the child. when the child is strapped in, the shoulder belt must pass the shoulder
at right angles to the backrest or feed slightly upwards (figure 4.1, pos. a).
if the shoulder belt feeds downwards (figure 4.1, pos. b), then the belt must be
repositioned and inserted through the next slot up.
to do this, proceed as follows:
Slip the two shoulder belts out of the connecting piece at the back of the seat.
then feed both belts back through the slot above and through to the back of the
seat before slipping them back onto the connecting piece (figure 4.2).
noTE!
The belts must not be twisted or crossed over.
Both sides must be adjusted equally.
infanT inSErT: the infant insert may be used for babies up to a weight of
approx. 8 kg. to remove the infant insert, unfasten the belt buckle and undo
the velcro fasteners on the infant insert. push the belts through the slits at the
side and remove the infant insert to the front (figure 4.3). to fit the infant insert,
proceed in the reverse order.
SEaT inSErT: the seat insert is located in the pocket on the back of the infant
insert and must be removed from a body weight of approx. 7 kg (figure 4.4).
19
Advertisement
