Samsung 400Txn Service Manual page 129

10 Operating Instructions and Installation
PIP(Picture in Picture) :
Push the PIP button to turn PIP screen On or Off.
BNC and Component cannot display PIP at the same time by using the same terminal.
-PC / DVI : TV / AV / S-Videos / Component Mode
-BNC: TV / AV / S-Video
-AV/ S-Video : PC / BNC / DVI Mode
-Component : PC / DVI Mode
POWER :
Use to turn the monitor on or off.
LED :
Lights up in normal mode. It blinks in green in Power Saver mode.
Remote Control Sensor: Receives the remote control signal.
10-1-1 Rear
The monitor's rear configuration may vary slightly depending on the monitor model.
-Connection Terminal
10-2
1. POWER S/W
2. POWER IN
3.RS232C OUT/IN
(RS232C Serial Input/Output Port):
MDC(Multiple Device Control)
Program Input/Output Port
4. PC IN(RGB) (PC Video Input Port)
: D-Sub(15 Pin) - PC Mode (Analog PC)
5. DVI IN(HDCP) (PC Video Input Port)
: DVI-D to DVI-D - DVI Mode (Digital PC)
6. PC/DVI/BNC AUDIO IN
(PC/DVI/BNC Audio Input Port)