Advertisement
I
NSTRUCTIONS
There are two ways to operate this caboose.
1) Auto allows you to operate the signalman with the bell button on any AC Transformer
equipped with a bell button or DCS Remote.*
2) Operating Track System (OTS) allows you to activate the signalman using the unloading
feature on your operating track sections.
Switch (Auto or OTS)
AUTO OPERATION
1) Move the switch on the bottom of the car to the Auto position
and place the caboose on track.
2) Hold down the bell button on your transformer or your DCS*
remote for 1-2 seconds
3) The caboose will automatically cycle. The signalman will swing
out with a lantern, and then will go back to the rear of the caboose,
ending the cycle.
4) Press the bell button again to begin another cycle.
* DCS operation is only possible on DCS Variable Tracks.
caboose in DCS mode.
1. The first is using the TIU Variable Channel, make sure the DCS signal is turned ON,
reduce the voltage to 21 volts and then press and hold the bell button down for 3-5
seconds to activate the caboose signal man.
2. If the customer has the Remote Receiver connected to the Z4000 transformer running
the TIU Fixed Channel, select the Z4K track and press the bell and hold the Bell button for
3-5 seconds to activate the caboose signal man.
instruction.
There are 2 ways to activate the
Refer to you DCS operating manual for
Advertisement
