Fm Settings Menu - Bush BR40DAB Instruction Manual

BR40DAB

FM Settings Menu

FM Settings Menu
There are also some menu setting that are specific to FM radio operation. These settings
may be changed through the Settings Menu.
To enter the FM Settings Menu:
Set to FM mode.
Press the MENU button.
A map of the menu is shown below. The menu is
navigated in the same way as the DAB+ settings
menu.
More Detail Of The FM Settings Menu Options:
Scan Setting: With this menu option you can set
the scanning sensitivity of the FM radio to two
different levels-'Strong stations only' or 'All stations'.
Setting to 'Strong stations only' will exclude weaker
stations resulting in a quicker scan. If you set to 'All
stations' the scan will stop at every station detected,
even if the signal is weak.
Audio Settings: This option enables you to set the radio to receive FM in Auto mode
(Mono/Stereo) or in Mono only. This may be useful if the signal is weak and the broadcast
is noisy.
System Settings: Allows you to set Tone Settings, Sleep Settings, Display
Settings, Time Settings, perform a Factory Reset and view the Software Version.
Tone Settings: Set the Bass volume & Trebel volume.
Sleep Settings: Select this option to set a sleep time in the range 15-90 minutes. When
a sleep time is set, the radio will set To Standby after the sleep delay time. Choose
'Sleep Off' to cancel sleep mode.
Display Setting: Select "Display set" then the "Active Backlight" sub-option to
change the backlight brightness. Press < or > to adjust the brightness level.
Press Select to enter the Standby Backlight sub-option. Press < or > to adjust the
brightness level during Standby Mode.
Time Setting: Select the time option to set the clock manually.
Factory Reset Setting: Select the 'Yes' sub-option to reset all the settings of your radio
to factory original settings. The station list will also be cleared and any stored preset
memories will be erased. After a factory reset the radio will re-scan the band and renew
the station list.
SW Version: This option will display the version number of the control software currently
installed in your radio. This will be helpful to a technician who is servicing the radio.
DISPLAY SETTING
- 15 -
SCAN SETTING
AUDIO SETTING
TONE SETTING
SLEEP SETTING
TIME SETTING
FACTORY RESET
SW VERSION