Fresh Air; Program Schedule And Holds; Understanding Program Schedules; Progressive Recovery - Aprilaire Control4 User Manual

Program schedule and holds

Fresh Air

If ventilation is installed, Fresh Air can operate in four different
modes as defined on this page.
Press button to select Fresh Air and enter the Fresh Air
screen.
Off: Ventilation will not run.
Automatic: Ventilation will cycle based on the parameters set by
the installer to meet your home's ventilation requirements.
3 Hour Event: Ventilation will be constantly energized for 3
hours and then the fresh air mode will return to Off or Automatic
depending on which was mode was most recently active. This
option is used when fresh air is needed. An example would be
after cooking.
24 Hour Event: Ventilation will be constantly energized for 24
hours and then the fresh air mode will return to Off or Automatic
depending on which was mode was most recently active. This
option is used when a large amount of fresh air is desired. An
example would be a day with desirable outdoor conditions.
Fresh Air screen
5
Program schedule and holds

Understanding program schedules

Setting the schedule for the thermostat is done at the Control4
system. Refer to the Control4 End User Climate Control
instructions for specific instructions for managing the thermostat
schedule.
The thermostat is shipped with programming disabled. Schedules
and program hold functionality will not be available until
programming is enabled by the Control4 system. If programming
is disabled, a program disabled message will appear in the
message center when the

Progressive recovery

The Progressive Recovery feature allows the thermostat to
activate the heating and cooling equipment prior to a scheduled
event in order to reach the desired temperature at the start of
that scheduled event.
Example: If the Next Event time is 6 a.m., and the temperature is
70°, the heat will come on before 6 a.m., so the temperature is
70° by 6 a.m.

Equipment wait

The thermostat implements equipment protection by enforcing
minimum equipment on and off times. If equipment is prevented
from coming on due to equipment protection an equipment
wait message will appear in the message center and the
corresponding equipment status icon will flash.
Fresh Air mode
selection
Fresh Air mode
adjustment
Done button
(save mode and
exit Fresh Air)
button is pressed.