Industry Canada Certification - Siemens Gigaset C28H Instruction Manual

Appendix
Handset operating times/charging
times
Capacity 550 mAh
Standby time Approx. 300 hours
(12.5 days)
Talk time Approx. 10 hours
Charge time Approx. 10 hours
The operating and charge times apply only
when using the recommended batteries.
General specifications
DECT 6.0 is supported
No. of channels 30 duplex channels
Radio frequency
range 1920–1930 MHz
Duplex method Time multiplex, 10ms
frame length
Channel grid 1728 kHz
Bitrate 1152 kbit/s
Modulation GFSK
Language code 32 kbit/s
Transmission 10 mW, average power per
power channel
Range Up to 984 feet outdoors,
up to 165 feet indoors
Charging cradle
power supply 110 V ~/60 Hz
Environmental +41°F to +113°F;
operating condi-
20% to 75% relative
tions
humidity
Dialing mode DTMF (tone dialing)/DP
(pulse dialing)

Industry Canada Certification

Operation is subject to the following two condi-
tions (1) this device may not cause interfer-
ence, and (2) this device must accept any inter-
ference, including interference that may cause
undesired operation of the device.
NOTICE: The Industry Canada label identifies
certified equipment. This certification means
that the equipment meets certain telecommu-
nications network, protective, operational and
16
safety requirements as prescribed in the appro-
priate Terminal Equipment Technical Require-
ments document(s). The Department does not
guarantee the equipment will operate to the
user's satisfaction.
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be installed
using an acceptable method of connection. The
customer should be aware that compliance
with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be coor-
dinated by a representative designated by the
supplier. Any repairs or alterations made by the
user to this equipment, or equipment malfunc-
tions, may give the telecommunications com-
pany cause to request the user to disconnect
the equipment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are
connected together.
This precaution may be particularly important
in rural areas
NOTE: Users should not attempt to make such
connections themselves, but should contact
the appropriate electric inspection authority,
or electrician, as appropriate.
This product meets the applicable Industry
Canada technical specifications.
A copy of the supplier's Declaration of Conform-
ity (SDoC) is available at this Internet address:
http://www.gigaset.com/docs.
The Ringer Equivalence Number is an indication
of the maximum number of devices allowed to
be connected to a telephone interface. The ter-
mination of an interface may consist of any
combination of devices subject only to the
requirement that the sum of the RENs of all
devices does not exceed five.
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est con-
forme à la norme NMB-003 du Canada.