Vaillant geotherm exclusive Installation Instructions Manual page 57

Heat pump with integrated domestic hot water cylinder and additional cooling function
Hide thumbs Also See for geotherm exclusive:
Table of Contents

Advertisement

Display shown
Mon. 21.04.08
Current flow temp.
CH pressure
Brine pressure
Heating only comp.
Warning message
Warning message
Table 8.3 Settable parameters in the operator level (ctnd.)
geoTHERM exclusive VWS 0020051614_00 installation instructions
Description
Energy input display
Shows the energy extracted from the environment for each of the 12
months of the current year (black bar). White-filled bars represent the
future months of the year; the height of the bar corresponds to the
yield for the month in the previous year (comparison possible). On
commissioning, the height of the bars is zero for all months, as no in-
formation is available yet.
The scaling (in the example, 4000 kWh) adapts automatically to the
month's highest value.
Top right the total of the environmental yield since commissioning is
displayed (in the example: 13628 kWh).
Day, date, time as well as flow temperature, heating system pressure
16:49
1
and heat source pressure are displayed.
28°C
IST flow temperature: Current flow temperature in the unit.
1.2bar
Heating system pressure: Heating circuit pressure sensor.
1.4bar
Pressure heat source: Heat source pressure (Pressure sensor for
heat source circuit; brine pressure)
Heating only comp.: this status message provides information on the
current operating status. The following are possible:
CH: Comp. only.
CH: Comp+Aux
CH: Aux only
CH: Comp&aux off
DHW: Comp&aux off
DHW: Comp only
DHW: Aux only
Peak Rate: WW
Peak Rate: Stand-by
Acceleration mode
Frost protection Heating
Frost protection Cylinder
Legionella protect.
Automatic pump spin
Floor drying
Venting mode
Fault shutdown: Heating
Error shutdown: Heating
Fault shutdown: DHW
Error shutdown: DHW
Malfunction
Blocking error
Operation interlock
CH Comp overrun
WW Comp overrun
Cooling & WW
CH return too high
Under critical operating conditions a warning message is displayed in
both lower display lines. These lines are empty when the operating
conditions are normal.
Controller 8
57

Advertisement

Table of Contents
loading

Table of Contents