Vaillant geotherm exclusive Installation Instructions Manual page 45

Fig. 6.23 Fitting the operating console
• Press the console terminal into the clip fastener of the
frame, then screw the control unit from behind, as
shown in Fig. 6.23.
Fig. 6.24 Fitting the front lower cladding
• Place the lower cladding on the frame, pull the supply
lines of the control unit through the frame and press
the cladding into the clip fastener on the casing.
Screw the console frame to the casing with both
screws, as shown in Fig. 6.24.
• If you have fitted the vrnetDIALOG communications
unit, plug in the connecting plug and the control cable
supplied in the heat pump accessory kit (see the vr-
netDIALOG manual and Chap. 6.9.3).
geoTHERM exclusive VWS 0020051614_00 installation instructions
Electrical installation 6
Fig. 6.25 Fitting and connecting the operating console
• Connect the connecting cable to the operating con-
sole.
Fig. 6.26 Fitting the front panel of the operating console
• Insert the front panel of the operating console into
the spring retainer on the console frame.
45